LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (28 - Ignition System -- CARRERA (997)) >> WM 282019 Removing And Installing Ignition Rod Module (Except Turbo Coupe, Turbo S Coupe, Turbo CABRIO & Turbo S CABRIO) >> Preliminary Work

Preliminary Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove rear wheel.

    Socket-Wrench Insert P300  should be used to avoid damaging the rims.

    → 44051900 REMOVING AND INSTALLING WHEEL .

  2. Remove rear silencer.

    → 263319 REMOVING AND INSTALLING REAR SILENCER .

  3. Remove upper part of heat shield.

    → 261219 REMOVING AND INSTALLING HEAT SHIELD .

    1. 3.1. Unscrew two M6 x 12 outer Torx screws (socket insert E10) and remove heat shield.
scientia non olet · About LEMON Manuals