LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (28 - Ignition System -- CARRERA (997)) >> 28 70 20 REMOVING AND INSTALLING SPARK PLUGS - as of MY 2005 (CARRERA 2, CARRERA 2S, CABRIO 2, CABRIO 2S, CARRERA 4, CABRIO 4) >> Installing >> Installing spark plugs

Installing spark plugs

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Incorrect tool 
  • Risk damage to components 

    • → Use prescibed tool

1. Install spark plug with spark plug socket wrench NR.14  with Extension, 3/8" WE 1637  and tighten to → Tightening torque: 22 ftlb.  If the spark plugs will be removed and installed again for another activity, the tightening torque for re-installation will be reduced to → Tightening torque: 19 ftlb. 

2. Insert ignition coils in the spark-plug recesses and tighten two M6 x 25 fastening screws on each one to → Tightening torque: 7.5 ftlb.  . Then push on the cable plugs and position the rubber sleeves on the coils.

3. Insert the heat shields again and tighten two fastening screws on each one to → Tightening torque: 7.5 ftlb.  .

scientia non olet · About LEMON Manuals