Subsequent Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

It may only be supported over a large area at the oil pan.
Localized loading is not permitted.

WARNING: Danger of objects or loads falling down

Risk of squashing or crushing

→ Secure components to prevent them from falling down.

Raise and secure the engine.
1. 1.1. Move the engine into installation position using the transmission jack by guiding the threaded bolts on the engine mountings through the engine carrier.
2. 1.2. Fit and tighten two M12 collar nuts (T55) on the threaded bolts.
  → Tightening torque: 85 Nm (63 ft. lb.)
3. 1.3. Slowly lower the transmission jack and remove it from the work area.
Install bumper and heat shield.
→ 635019 REMOVING AND INSTALLING REAR BUMPER .
Install heat shield on the catalytic converter.
→ 635019 REMOVING AND INSTALLING REAR BUMPER .
Install charge-air cooler.
→ 214319 REMOVING AND INSTALLING CHARGE-AIR COOLER .
Install rear apron.
→ 635519 REMOVING AND INSTALLING REAR APRON .