Preliminary Work
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
- Remove rear apron.
- Remove charge-air cooler.
- Remove heat shield over the catalytic converter.
- Remove bumper with heat shield.
→ 635019 REMOVING AND INSTALLING REAR BUMPER .
WARNING: Danger of objects or loads falling down- Risk of squashing or crushing
→ Secure components to prevent them from falling down.
Information
- It may only be supported over a large area at the oil pan.
- Localized loading is not permitted.
Information
- When lowering, the engine must not rest on the rear axle cross member.
- Lower the engine.
- 5.1. Support the engine at the oil pan with a transmission jack.
Transmission and unit jack Junior Jack 2.0 WE 1223; GA passenger car transmission plate WE 1224
- 5.2. Loosen two M12 collar nuts (T55) on the rear engine mountings.
- 5.3. Slowly lower the engine using the transmission jack.
- 5.1. Support the engine at the oil pan with a transmission jack.