Subsequent Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Secure the engine.
1. 1.1. Lift the engine into installation position using the hydraulic jack and guide the threaded bolts of the engine mounting into the engine carrier.
2. 1.2. Tighten two special M12 nuts (internal Torx, screw insert T55) on the engine mounting (hydraulic mount) at the left and right.
  → Tightening torque: 85 Nm (63 ft. lb.)
Install bumper and heat shield.
→ 635019 REMOVING AND INSTALLING REAR BUMPER .
Install heat protection panel on catalytic converter.
→ 635019 REMOVING AND INSTALLING REAR BUMPER .
Install charge air cooler.
→ 214319 REMOVING AND INSTALLING CHARGE AIR COOLER .
Install the rear apron.
→ 635519 REMOVING AND INSTALLING REAR APRON .