Subsequent Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fit oxygen sensors.
1. 1.1. Grease oxygen sensor thread lightly with Optimol Paste MF before refitting (Part No. 000.043.207.07).
2. 1.2. Turn oxygen sensor cable and sensor by four turns in an anti-clockwise direction.
3. 1.3. Screw in each oxygen sensor on the catalytic converter as far as possible by hand.
4. 1.4. Tighten the oxygen sensor.
  → Tightening torque: 50 Nm (37 ft. lb.)
Route oxygen sensor cable and clip it in
1. 2.1. Connect plug connection in the engine compartment.
Install air cleaner housing.
→ 242519 REMOVING AND INSTALLING AIR CLEANER HOUSING .