Subsequent Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Objects or loads falling down

Risk of squashing or crushing

→ Secure components to prevent them from falling down.

Information

It may only be supported over a large area at the oil pan.
Localized loading is not permitted.

Information

When lowering, the engine must not rest on the rear axle cross member.

Secure the engine.
1. 1.1. Move the engine into installation position using the transmission jack.
2. 1.2. Fit and tighten two M12 collar nuts (T55) on the threaded bolts for the engine mountings.
  → Tightening torque: 85 Nm (63 ft. lb.)
3. 1.3. Lower the transmission jack and move it out of the work area.
Install bumper and heat shield.
→ 635019 REMOVING AND INSTALLING REAR BUMPER .
Install heat shields for the catalytic converters.
→ 635019 REMOVING AND INSTALLING REAR BUMPER .
Install charge-air cooler.
→ 214319 REMOVING AND INSTALLING CHARGE-AIR COOLER .
Install rear apron.
→ 635519 REMOVING AND INSTALLING REAR APRON .