Subsequent Work On DME Control Unit
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Remove the cover above the heating/air-conditioning system and fluid tank.
If a new DME control unit is installed, then read out the vehicle data from the DME control unit and transfer them to the new one.
- Connect the PIWIS Tester 9718 to the vehicle and start the System Tester. Switch on ignition. Press [>>] to continue.
- Select vehicle type. Press [>>] to continue.
- Carry out automatic search of control units.
- Select DME with the cursor keys and press the [>>] key.
- Select Program control unit with the cursor keys and press the [>>] key.
- Select Read out vehicle data (Vehicle data) with the cursor keys and press the [>>] key.
- The message Reading vehicle data will appear on the tester screen.
- After replacement of the DME control unit, the vehicle data is uploaded from the Program control unit menu option.