LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (24 - Fuel System - Electronic Ignition -- CARRERA (997)) >> WM 247019 Removing And Installing DME (DFI) Control Unit (Turbo Coupe, Turbo S Coupe, Turbo CABRIO, Turbo S CABRIO, Gt2 & Gt2 RS) >> Preliminary Work >> Preliminary Work For DME (DFI) Control Unit

Preliminary Work For DME (DFI) Control Unit

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

If a BOSE subwoofer is installed, remove the subwoofer. → 91361900 REMOVING AND INSTALLING SUBWOOFER - section on "Removing".

Lift up and remove the carpet trim behind the back rest.

If a new DME control unit is to be installed, read out the vehicle data from the DME control unit and copy it to the new one.

  1. PIWIS Tester II 9818  must be connected to the vehicle before starting the System Tester. Switch on ignition.
  2. Select the vehicle type and start the PIDT.
  3. Select DME/DFI  , Maintenance/repairs  .
  4. Select the Control unit replacement  menu and press [F12] to continue.
  5. Select Read data  (vehicle data) and press [F8] to start.
  6. The message Data was read out  appears on the Tester screen. Press [F12] to continue.
  7. Once the DME control unit has been replaced, the data that was read out is loaded in the Control unit replacement  menu when you press [F8] (Write data)  . Press [F12] to continue.
scientia non olet · About LEMON Manuals