LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (24 - Fuel System - Electronic Ignition -- CARRERA (997)) >> WM 246919 Removing And Installing Oxygen Sensors Upstream Of Catalytic Converter (Except Turbo Coupe, Turbo S Coupe, Turbo CABRIO & Turbo S CABRIO) >> Subsequent work

Subsequent work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Danger of objects or loads falling down
  • Risk of squashing or crushing

→ Secure components to prevent them from falling down.

  1. Route oxygen sensor cable in engine compartment and secure in the retaining clips.
    1. 1.1. Close plug connections and insert into the holders.
  2. Install air cleaner housing.

    → 242519 REMOVING AND INSTALLING AIR CLEANER HOUSING .

  3. Mount rear wheel.

    → 44051900 REMOVING AND INSTALLING WHEEL .