Subsequent Work
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
- Install coolant regulator housing cover.
→ 195519 REMOVING AND INSTALLING HOUSING FOR COOLANT REGULATOR .
- Fill in coolant and bleed the cooling system.
→ 193817 DRAINING AND FILLING COOLANT (INCLUDES BLEEDING THE SYSTEM) .
- Fit and tension the drive belt.
- Connect the battery.
→ 2X00IN02 WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY .
- Start the system for the first time.
→ 2001IN BLEEDING FUEL SYSTEM HIGH-PRESSURE SIDE (FIRST START FUNCTION) .
- If the high-pressure pump was replaced, a high-pressure adaptation is required.