Removing Mass Air Flow Sensor

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Unscrew two Torx tapping screws (T25 screw insert) -2- .

Fig 1: Identifying Hot-Film MAF Sensor
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Pull out mass air flow sensor -1- .
1. 2.1. Check O-ring -2- and replace it if necessary.
2. 2.2. Grease new O-ring lightly with Kluber Syntheso Glep (Part No. 000.043.204.68).
  
  Fig 2: Identifying Hot-Film MAF Sensor With O-Ring
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.