Subsequent Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Install engine carrier.
→ 103019 REMOVING AND INSTALLING ENGINE CARRIER - section on "Installing"
Install front silencer.
→ 262519 REMOVING AND INSTALLING FRONT SILENCER - section on "Installing"
Install number plate and retainer plate.
Install the generator.
Fit the generator and tighten M8 external Torx screws (E12) -1 and 2- .

→ 272219 REMOVING AND INSTALLING GENERATOR - section on "Installing"

Fig 1: Identifying Generator Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Install hydraulic pump.
→ 489819 REMOVING AND INSTALLING HYDRAULIC PUMP - section on "Installing"
Install air-conditioning compressor.
→ 873419 REMOVING AND INSTALLING AIR-CONDITIONING COMPRESSOR - section on "Installing"
Fit drive belt -1- .
→ 137819 REMOVING AND INSTALLING DRIVE BELT - section on "Installing"
1. 7.1. Turn the tensioner -3- clockwise at the hexagon (a/f 30) using a ring wrench -2- and fit the belt.
2. 7.2. Allow the tensioner to slide back to its initial position.
Fig 2: Fitting Drive Belt
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Install (center) intake-air distributor.
→ 244619 REMOVING AND INSTALLING INTAKE-AIR DISTRIBUTOR - TURBO - section on "Installing"
Install air cleaner housing.
→ 242519 REMOVING AND INSTALLING AIR CLEANER HOUSING - TURBO - section on "Installing"
Fill in coolant.
→ 193817 DRAINING AND FILLING COOLANT (INCLUDES BLEEDING) - section on "Filling"
Let the engine run until warm and visually check for leaks.
Remove protective covers from the vehicle.