Subsequent Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Raise the engine.
Raise the engine into installation position with a jack, using Retainer Plate P 9592 to do this.

Screw in and tighten M12 collar nuts -1- .

→ Tightening torque: 85 Nm (63 ft. lb.)

Fig 1: Engine Carrier To Engine Mounting (Cylinder Bank 4-6)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fill in coolant and bleed the system.
→ 193817 DRAINING AND FILLING IN COOLANT (INCLUDES BLEEDING) .
Install air cleaner housing.
→ 242519 REMOVING AND INSTALLING AIR CLEANER HOUSING - section on "Installing".
Test-drive the vehicle and correct the engine coolant level in the reservoir if necessary (observe Min/Max marking).