Installing Flap Motor

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Insert motor in the spindle mounting -1- and in the bracket for the rear panel flap -2- .

Fig 1: Inserting Flap Motor
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Screw down motor with the four fastening screws -3- .
Information

When installing the flat connectors with the electric connecting lines, the correct installation position in the central connector (see 9797IN CONNECTOR - GENERAL INFORMATION ) must be observed.
Insert the two flat connectors with the electric connecting lines -1- in the central connector -2- -arrows- until they are felt to engage.

Fig 2: Installing Cable Connections
Courtesy of PORSCHE CARS NORTH AMERICA, INC.