LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2015 >> Boxster Base, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 163 (42 - Rear Wheel Suspension, Drive Shafts -- CARRERA (997)) >> WM 425219 Removing And Installing Rear Wheel Bearing Housing (Wheel Carrier) (Except 911 Turbo S Coupe "Ed. 918 SPYDER", 911 CARRERA 4 GTS, 911 CARRERA 4 GTS CABRIO, 911 Gt3 RS 4.0) >> Subsequent Work

Subsequent Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fit wheel → INSTALLING WHEEL .
  2. Tighten axle nut (drive shaft to wheel bearing housing) if it was removed (vehicle lowered, brakes operated by 2nd fitter).

    → Tightening torque: 460 Nm (340 ftlb.) 

  3. Check wheel alignment values and adjust if necessary. → 449503 PERFORMING FRONT AND REAR SUSPENSION ALIGNMENT .
scientia non olet · About LEMON Manuals