LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2012 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (10 - Engine - Crankcase, Suspension 4.8L Turbo -- 970 - PANAMERA (970)) >> WM, 103719 Removing And Installing Torque Support >> Removing Torque Support

Removing Torque Support

WARNING: This page is about a different variant/trim than selected.
  1. Remove the two screws and nuts on the body and valve cover.
  2. Remove torque support.
    Fig 1: Torque Support Components Location
    G15197891Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Installation position of torque support

1  Aluminium screw, M10
2  M10 nut; counter when using tools.
3  Bracket on valve cover
4  Bracket on body
5  Torque support part identification on the back, must be installed in opposite direction to direction of travel.
scientia non olet · About LEMON Manuals