Installing Left Engine Mount

Information 

The tightening specifications for the basic engine are stored centrally.

> TECHNICAL VALUES

/

> WM 2X00IN TECHNICAL VALUES (PANAMERA, PANAMERA S, PANAMERA S EXECUTIVE, PANAMERA 4, PANAMERA 4S, PANAMERA 4 S EXECUTIVE)

or

> 1001IN TIGHTENING TORQUES, TIGHTENING SEQUENCES AND ASSEMBLY OVERVIEWS 

Tightening torques and assembly instructions for other assemblies (e.g. chassis, electrics, transmission or body) or for peripheral engine equipment can be found in the corresponding documents.

1. Guide engine mount into the mounting provided for it.
2. Guide the engine mount guide pin into the groove provided for it -arrow-  so that it can no longer pop out.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Guide pin

3. Press against the engine mount from below -arrow-  and tighten the fastening nuts on the engine mount > Nr.89 Pos.3 - Connecting piece  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Securing engine mount (figure shows 4WD turbo engine)

4. Place heat shield in installation position. Fit and tighten four fastening screws -arrows-  for the heat shield.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Screws on heat shield (illustration shows removed primary catalytic converter, but left primary catalytic converter remains fitted)