LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2012 >> Cayenne S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (10 - Engine - Crankcase, Suspension (4.8L Turbo) -- 92A - Cayenne (92A)) >> WM, 103719 Removing And Installing Torque Support >> Removing Torque Support

Removing Torque Support

WARNING: This page is about a different variant/trim than selected.
  1. Remove the two screws and nuts on the body and valve cover > Installation position of torque support (position of secondary air pump differs in illustration)  .
    G16307080Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Installation position of torque support (position of secondary air pump differs in illustration)

    1  Aluminum screw, M10
    2  M10 nut; counter when using tools.
    3  Bracket on valve cover
    4  Bracket on body
    5  Torque support; part identification on the back, must be installed in opposite direction to direction of travel.
  2. Remove torque support.
scientia non olet · About LEMON Manuals