LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2012 >> Cayenne S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (10 - Engine - Crankcase, Suspension (4.8L Turbo) -- 92A - Cayenne (92A)) >> WM, 103519 Removing And Installing Engine Mounting >> Installing Engine Mounting

Installing Engine Mounting

WARNING: This page is about a different variant/trim than selected.

Information 

The tightening specifications for the basic engine are stored centrally.

> 1X00IN TECHNICAL VALUES

/

> 2X00IN TECHNICAL VALUES

or

> 1001IN TIGHTENING TORQUES, TIGHTENING SEQUENCES AND ASSEMBLY OVERVIEWS .

Tightening torques and assembly instructions for other assemblies (e.g. chassis, electrics, transmission or body) or for peripheral engine equipment can be found in the corresponding documents.

  1. The engine mounting is installed in reverse order to removal.
  2. Tighten the fastening screws on the heat shield to > Tightening torque 10 (7.5 ftlb.) Nm  .
  3. Tighten fastening screws securing the engine carrier to the hydraulic mount.
  4. Tighten fastening nuts securing the hydraulic mount to the bracket for auxiliary units.
  5. Tighten fastening screw securing the bracket for auxiliary units/engine mounting to lower part of crankcase.
scientia non olet · About LEMON Manuals