On-board computer

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Some functions of the on-board computer display are linked with the data of the navigation unit: The time is set automatically according to the data determined by the GPS receiver; thus, the only work required involves setting the time zone once.

The route to the destination is known if the route guidance function is activated in the navigation unit. The length of this route is displayed as the distance to the destination. The range display allows an estimate about whether the fuel supply is adequate for the remaining distance.

The estimated time of arrival is calculated on an individual basis according to the driving style and the planned route: The navigation unit informs the on-board computer about the different road categories along the route and the length of these road sections.

The on-board computer calculates a different individual average driving speed for each road category. This information is used to calculated the planned time of arrival - if no traffic-related delays occur - on an individual basis.

The on-board computer also supplies standard information, for instance the average consumption, average speed, distance travelled, and elapsed driving time. The outside temperature is adopted from the instrument cluster. It is possible to set a limit that triggers a visual and audible speed warning.

It is also possible to switch to different units of measure and languages and adjust the display contrast.

The A/C function is limited to the display of data transferred from the air-conditioning regulator.

Fan setpoint
Passenger compartment temperature setpoint
Air distribution
Status display (automatic system, defroster, A/C compressor, air circulation)

The display is activated automatically whenever a manual adjustment is made on the air conditioning regulator or the A/C function is specifically selected.