Input signals

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

The following queries can be run using this menu item:

Signal, reverse gear navigation unit

NOTE: Deactivate the automatic traffic announcement before performing the diagnosis on the PCM2. If this is not done, the diagnosis will abort.

INPUT SIGNALS - SIGNAL, REVERSE GEAR NAVIGATION UNIT

Menu item	Function
Reverse-gear signal	The reverse-gear signal can be read out using this menu item. Connect and start the Porsche System Tester II 9588 and switch on the ignition. Select 911 (996) in the Vehicle type menu and confirm with the "FORWORD" key. Select PCM in the Control modules menu and confirm with the "FORWORD" key. Select Navigation in the 911 (996) PCM2 function selection and confirm with the "FORWORD" key. Select Input signals in the 911 (996) Navigation function selection and confirm with the "FORWORD" key. Select Reverse-gear signal in the 911 (996) Navigation input signals function selection and confirm with the "FORWORD" key. Read out values from the display field.

Menu item

Function

Reverse-gear signal

The reverse-gear signal can be read out using this menu item.

Connect and start the Porsche System Tester II 9588 and switch on the ignition.
Select 911 (996) in the Vehicle type menu and confirm with the "FORWORD" key.
Select PCM in the Control modules menu and confirm with the "FORWORD" key.
Select Navigation in the 911 (996) PCM2 function selection and confirm with the "FORWORD" key.
Select Input signals in the 911 (996) Navigation function selection and confirm with the "FORWORD" key.
Select Reverse-gear signal in the 911 (996) Navigation input signals function selection and confirm with the "FORWORD" key.
Read out values from the display field.