LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2011 >> 911 Speedster >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 13 - Engine - CRANKGEAR, Pistons -- CARRERA (997) >> WM 136319 Removing And Installing Drive Plate For Converter (CARR. Coupe, CARR. S Coupe, CARR. CABRIO, CARR. S CABRIO, CARR. 4 Coupe, CARR. 4S Coupe, TARGA 4, TARGA 4S, CARR. 4 CABRIO, CARR. 4S CABRIO) >> Installing Drive Plate For Converter

Installing Drive Plate For Converter

  1. Position drive plate on the crankshaft's dowel pin and press on to the crankshaft flange. Insert all M10 x 25 fastening screws (8).
  2. Align toothed segment 9538/1 and tighten fastening screw again.
  3. Screw in and tighten fastening screws in diagonally opposite sequence. Initial tightening: 25 Nm (ftlb.) (19); → Final tightening - torque angle: 120°
  4. Remove toothed segment.
scientia non olet · About LEMON Manuals