| Fastening screws and fastening nuts in convertible top support |
M8 |
Tightening torque |
23 Nm (17 ftlb.) |
|
|
| Fastening screw for securing deflection fitting in belt guide section mounting. |
M8 |
Tightening torque |
50 Nm (37 ftlb.) |
|
|
| Fastening nut M8, hydraulic cylinder to convertible top support |
|
Tightening torque |
17 Nm (13 ftlb.) |
+/-2 Nm (+/- 1.5 ftlb.) |
|
| Upper edge molding of rear side panel to side window |
front |
Gap dimension C |
11 mm |
|
|
| Upper edge molding of rear side panel to side window |
rear |
Gap dimension D |
14 mm |
|
|
| Side window to door window |
|
Gap dimension E |
9 mm |
+/-1 mm |
|
| Adjusting elements for door window |
|
Tightening torque |
23 Nm (17 ftlb.) |
|
|
| Fastening screws (M6) on rear window inner seal |
|
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|