Adjusting the rear side section trim

WARNING: This page is about a different variant/trim than selected.

Fig 1: Adjusting Gap Dimensions Of Rear Side Section Trim

Courtesy of PORSCHE OF NORTH AMERICA, INC.

(Convertible top open and set down.) Insert a plastic spatula under the trim and press it out. The height adjustment is made using the fastening screws -D1- in the flap. See Fig 1. See TEST AND ADJUSTMENT VALUES .

Set the gap dimension -D- rear side section flap to the side trim panel. See Fig 1. See TEST AND ADJUSTMENT VALUES .
Set the gap dimension -E- rear side section flap to the side trim panel. See Fig 1. See TEST AND ADJUSTMENT VALUES .
Set the gap dimension -F- rear side section flap to frame trim panel for the roll-over protection system. See Fig 1.
See TEST AND ADJUSTMENT VALUES .