Installing potentiometer for convertible-top interrogation
WARNING: This page is about a different variant/trim than selected.
- Installing and locking new contacts of the potentiometer wires
Install the new contacts of the potentiometer in the same position as follows:
Green wire (pin 1) to pin 9
Yellow wire (pin 2) to pin 4
Red wire (pin 3) to pin 8
Close the secondary lock of the plug connection with a small screwdriver again.
- Winding insulating tape around wires
- Installing potentiometer
Tighten potentiometer with fastening screws.
- Laying wire
Engage electrical plug connection.
- Installing hydraulic cylinder and rear left side-panel lining