LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 Carrera 4S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Passenger Protection) >> Removing and installing the side airbag unit >> Installing side airbag unit >> Installation

Installing side airbag unit: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check sensor for the side airbag unit for damage and, if necessary (e.g. after the third time the side airbag is triggered), replace it. See REMOVING AND INSTALLING SENSOR FOR SIDE AIRBAG  .
  2. Check the covering film behind the side airbag unit for damage. It protects against water leaking in.
  3. Insert the side airbag unit identified with an R into the right door and the unit identified with an L into the left door.
  4. Tighten four new, micro-encapsulated M6x16 fastening screws.
  5. Make electrical plug connection.
  6. Tighten M5x10 fastening screw and push on the cover with the inscription Airbag.
  7. Install the door panel, see DISASSEMBLING AND ASSEMBLING DOOR .
  8. Connect the battery.
scientia non olet · About LEMON Manuals