Installing pivot-pin locks
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Insert the pivot-pin locks -B- when the convertible top is open and the side panel lining has been removed. Refer to REMOVING AND INSTALLING SIDE-PANEL LINING . Removing and installing side panel lining. The fitting bolt -C- can only be screwed in when the convertible top is closed. See Fig 1 .
- The requirement for fitting the pivot-pin lock is that the installation (bracket -A-) for hardtop is installed. See REMOVING AND INSTALLING HARDTOP FASTENINGS . See Fig 1 .
- The pivot-pin lock -B- is inserted into bracket -A- and screwed tightly with the fastening screws -1- . Bear in mind here that there is a left-hand and right-hand pivot-pin lock. (Observe the inscription L or R on the pivot-pin lock). See Fig 1 .
- The locking tab of the bracket must correspond to the recess of the pivot-pin lock. By tightening, see TIGHTENING TORQUES , the fitting lock -C-, the pivot-pin lock -B- is clamped in the bracket -A-. See Fig 1 .
- Press plastic cover -D- into the pivot-pin locks. See Fig 1 .