Overviews of available menus

• Identification
• Fault memory
• Erase fault memory
• Drive links
• Actual values
• Input signals
• Static test
• Bleed: In the case of ABS 5.3 (Solo ABS), the menus are not necessary and are therefore not present.
• Coding (extract / modify): In the case of ABS 5.3 (Solo ABS), the menus are not necessary and are therefore not present.

Identification: Display of the diagnosis software number and the control module part number.

Fault memory: see FAULT MEMORY 

Drive links: see DRIVE LINKS (ABS AND ABS/TC) 

Actual values: see ACTUAL VALUES (ABS AND ABS/TC) 

Input signals: see INPUT SIGNALS (ABS AND ABS/TC) 

Static test: see STATIC TEST (ABS AND ABS/TC) 

Bleed: see BLEEDING 

Extract coding/ Modify coding: see MENU: CODING (ABS/TC 5.3)