LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 1.8L (Lay)) >> Repair Instructions - On Vehicle >> Engine Mount Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
WARNING: Refer to Battery Disconnect Warning in the Preface section.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection And Connection .
  2. Raise and properly support the engine. Refer to Engine Support Fixture .
    3. Fig 1: Identifying Engine Mounting Insulator Bolts - Right Side
    GM2016921Courtesy of GENERAL MOTORS CORP.
  3. Remove the bolt and 2 nuts (1, 2), and separate the engine mounting insulator RH.
    4. Fig 2: View Of Radiator Surge Tank Assembly Bolts
    GM2016941Courtesy of GENERAL MOTORS CORP.
  4. Remove the 3 bolts (1-3) and radiator reserve tank.
    Fig 3: View Of Engine Mounting Insulator Bolts - Right Side
    GM2016944Courtesy of GENERAL MOTORS CORP.
    NOTE: Perform this procedure only when replacement of the engine mounting insulator is necessary.
  5. Remove the 3 bolts (1-3) and engine mounting insulator RH.
scientia non olet · About LEMON Manuals