Conditions for Clearing the MIL/DTC

WARNING: This page is about a different variant/trim than selected.

The DTC will clear when conditions for setting the DTC have been repaired.

Step	Action	Values	Yes	No
Schematic Reference: Automatic Transmission Controls Schematics Connector End View Reference: Component Connector End Views
1	Did you perform the Diagnostic System Check - Vehicle?	-	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Turn the ignition to OFF. Remove the shift solenoid valve SLU. Measure the resistance between terminals 1 and 2 of the solenoid valve connector. Connect the positive lead with a 21 watt bulb to terminal 2 and the negative lead to terminal 1 of the solenoid valve connector, then check the movement of the valve. Is the resistance measured within specified value and does the solenoid make an operating sound?	5 to 5.6 Ohms	Go to Step 3	Go to Step 5
3	Inspect transmission valve body assembly for foreign objects and each valve operates smoothly. Is transmission valve body operation OK?	-	Go to Step 4	Go to Step 6
4	Inspect torque converter clutch assembly for normal operation. Is torque converter clutch operation OK?	-	Go to Step 8	Go to Step 7
5	Replace the shift solenoid valve SLU. Did you complete the replacement?	-	Go to Step 8	-
6	Replace the transmission valve body assembly. Did you complete the replacement?	-	Go to Step 8	-
7	Replace the torque converter clutch assembly. Did you complete the replacement?	-	Go to Step 8	-
8	Use the scan tool in order to clear the DTC. Operate the vehicle within the Conditions for Running the DTC, as specified in the supporting text. Does the DTC reset?	-	Go to Step 2	System OK