Conditions for Clearing the MIL/DTC

WARNING: This page is about a different variant/trim than selected.

The DTC will clear when conditions for setting the DTC have been repaired.

Step	Action	Values	Yes	No
Schematic Reference: Automatic Transmission Controls Schematics Connector End View Reference: Component Connector End Views
1	Did you perform the Diagnostic System Check - Vehicle?	-	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Inspect for proper speed sensor installation. Is the installation bolt tightened properly and there is no clearance between the speed sensor and transaxle case?	-	Go to Step 3	Go to Step 6
3	Turn the ignition to OFF. Disconnect the speed sensor connector B91 from the transaxle. Measure the resistance between connector B91 terminals 1 and 2. Is the resistance measured within specified value?	560 to 680 Ohms	Go to Step 4	Go to Step 6
4	Connect the speed sensor connector B91. Disconnect the ECM connector C19. Measure the resistance as follows: Between connector C19 terminals 125 and 124. Between connector C19 terminal 125 and body ground. Between connector C19 terminal 124 and body ground. Is the resistance measured within specified value?	Between C19 terminals 125 and 124 = 560 to 680 Ohms Between C19 terminal 125 and body ground = 10 Kohms or higher Between C19 terminal 124 and body ground = 10 Kohms or higher	Go to Step 7	Go to Step 5
5	Repair or replace harness or connector of the ECM. Refer to Wiring Repairs and Connector Repairs . Did you complete the repair or replacement?	-	Go to Step 8	-
6	Replace the speed sensor. Refer to Vehicle Speed Sensor Replacement . Did you complete the replacement?	-	Go to Step 8	-
7	Replace the ECM. Refer to Control Module References . Did you complete the replacement?	-	Go to Step 8	-
8	Use the scan tool in order to clear the DTC. Operate the vehicle within the Conditions for Running the DTC, as specified in the supporting text. Does the DTC reset?	-	Go to Step 2	System OK