LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission - MVB 4 Speed) >> Diagnostic Information and Procedures >> DTC P0710-P0713 >> Conditions for Clearing the MIL/DTC

Conditions for Clearing the MIL/DTC

WARNING: This page is about a different variant/trim than selected.

The DTC will clear when conditions for setting the DTC have been repaired.

Step Action Values Yes No
Schematic Reference: Automatic Transmission Controls Schematics 
Connector End View Reference: Component Connector End Views
1 Did you perform the Diagnostic System Check - Vehicle? - Go to Step 2  Go to Diagnostic System Check - Vehicle
2
  1. Install a scan tool.
  2. Turn ON the engine.
  3. Select the A/T Oil Temperature 1 parameter on the scan tool.
Does the ATF temperature display between -40°C (-40°F) or above 150°C (302°F)?		 - Refer to Testing for Intermittent Conditions and Poor Connections Go to Step 3 
3
  1. Turn the ignition to OFF.
  2. Disconnect the transmission connector B90.
  3. Measure the resistance as follows:
    • Between connector B90 terminals 1 and 6.
    • Between connector B90 terminal 1 and body ground.
    • Between connector B90 terminal 6 and body ground.
Is the resistance measured within specified value?		 Between terminals 1 and 6 = 79 Ohms to 156 Kohms
Between terminal 1 and body ground = 10 Kohms or higher
Between terminal 6 and body ground = 10 Kohms or higher		 Go to Step 4  Go to Step 5 
4
  1. Connect the transmission connector B90.
  2. Disconnect the ECM connector C19.
  3. Measure the resistance as follows:
    • Between connector C19 terminals 72 and terminal 95.
    • Between connector C19 terminal 72 and body ground.
    • Between connector C19 terminal 95 and body ground.
Is the resistance measured within specified value?		 Between C19 terminals 72 and 95 = 79 Ohms to 156 Kohms
Between C19 terminal 72 and body ground = 10 Kohms or higher
Between C19 terminal 95 and body ground = 10 Kohms or higher		 Go to Step 7  Go to Step 6 
5 Repair or replace harness or connector of the transmission. Refer to Wiring Repairs and Connector Repairs .
Did you complete the repair or replacement?		 - Go to Step 8  -
6 Repair or replace harness or connector of the ECM. Refer to Wiring Repairs and Connector Repairs .
Did you complete the repair or replacement?		 - Go to Step 8  -
7 Replace the ECM. Refer to Control Module References .
Did you complete the replacement?		 - Go to Step 8  -
8
  1. Use the scan tool in order to clear the DTC.
  2. Operate the vehicle within the Conditions for Running the DTC, as specified in the supporting text.
Does the DTC reset?		 - Go to Step 2  System OK
scientia non olet · About LEMON Manuals