LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 49 (Parking Brake System) >> Repair Instructions >> Parking Brake Actuator Replacement (J55) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the actuator lever to the backing plate.
  2. Install the park brake shoe. Refer to Parking Brake Shoe Replacement .
  3. Adjust the park brake shoe. Refer to Parking Brake Adjustment (J55) .
  4. Install the rotor. Refer to Rear Brake Rotor Replacement (J55) or Rear Brake Rotor Replacement (JL9) .
  5. Install the rear park brake cable to the park brake actuator lever.
    6. Fig 1: Removing/Installing Intermediate Cable At Right Rear Park Brake Cable
    GM106224Courtesy of GENERAL MOTORS CORP.
  6. Connect the left rear park brake cable (2) to the rear equalizer (1).
  7. Connect the right rear park brake cable (5) to the intermediate park brake cable (3).
  8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  9. Remove the safety stands.
  10. Lower vehicle.
scientia non olet · About LEMON Manuals