Installation Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Shift Cable & Grommet

Courtesy of GENERAL MOTORS COMPANY

Install the shift cable through the cowl panel and seat the grommet.

Fig 2: View Of Transmission Shift Cable & Tabs

Courtesy of GENERAL MOTORS COMPANY

Slide the transaxle range selector cable (2) fully into the bracket until it snaps into place.

Fig 3: View Of Transmission Shift Cable & Linear Shift Assembly

Courtesy of GENERAL MOTORS COMPANY

Connect the transaxle range selector cable terminal to the shift lever pin.

Fig 4: View Of Transmission Shift Cable Clip

Courtesy of GENERAL MOTORS COMPANY

Install the retainer to the transaxle range selector cable mechanism.
Install the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .

Fig 5: Identifying Manual Shift Lever & Shift Cable

Courtesy of GENERAL MOTORS COMPANY

Insert the transaxle range selector cable (2) into the bracket.
Connect the transaxle range selector cable terminal to the transaxle manual shift lever pin (1).
Install the retainer to the transaxle range selector cable mechanism.
Adjust the automatic transmission range selector cable. Refer to Range Selector Lever Cable Adjustment .