Installation Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Coil Spring & Compressor

Courtesy of GENERAL MOTORS COMPANY

Install the coil spring in the J 44255 .

Fig 2: View Of Lower Control Arm & Coil Spring

Courtesy of GENERAL MOTORS COMPANY

Install the spring ensuring the insulator is seated in the control arm.

Fig 3: Identifying Shock Absorber Lower Retaining Bolts

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

Refer to Fastener Caution .

Raise the lower control arm and install the 2 shock bolts in the control arm.
Tighten

Tighten the shock bolts to 25 N.m (18 lb ft).

Fig 4: View Of Control Arm, Air Tube, Shock & Bolts

Courtesy of GENERAL MOTORS COMPANY

Install the adjustment link to the control arm.
Tighten

Tighten the adjustment link to 30 N.m (22 lb ft), then tighten an additional 180 degrees.
Connect the electronic level control air tube to the shock.
Install the tires and the wheels. Refer to Tire and Wheel Removal and Installation .
Tighten

Tighten the wheel nuts to 125 N.m (80 lb ft).
Lower the vehicle.
Check the toe and adjust if necessary. Refer to Rear Toe Adjustment (FE1, FE3) , Rear Toe Adjustment (FE7) .