Installation Procedure
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
- Install the adjustment link to the support assembly.
- Install the cam lock nut, washer and bolt.
Tighten
Tighten the cam lock nut to 91 N.m (67 lb ft).
- Install the adjustment link to the control arm.
- Install the adjustment link nut.
Tighten
Tighten the nut to 30 N.m (22 lb ft) then tighten an additional 180 degrees.
- Install the rear suspension support. Refer to Rear Support Replacement (w/FE1, FE3) , Rear Support Replacement (w/FE7) .
- Install the exhaust. Refer to Exhaust System Replacement .
- Lower the vehicle.
- Check the rear toe adjustment. Refer to Rear Toe Adjustment (FE1, FE3) , Rear Toe Adjustment (FE7) .
CAUTION:
Refer to Fastener Caution .