LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 123 (Engine Controls And Fuel - 4.6L - Repair Instructions) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Accelerated Pedal Nuts
    GM1671028Courtesy of GENERAL MOTORS COMPANY
  1. Install the accelerator pedal.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the accelerated pedal nuts.

    Tighten 

    Tighten the nuts to 10 N.m (89 lb in).

    3. Fig 2: Identifying Accelerator Pedal Position (APP) Sensor
    GM1671027Courtesy of GENERAL MOTORS COMPANY
  3. Connect the body harness electrical connector (1) to the APP sensor.
  4. Install the left I/P sound insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
scientia non olet · About LEMON Manuals