LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Mechanical - 4.6L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Oil Level Sensor and/or Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air conditioning (A/C) compressor. Refer to Air Conditioning Compressor Replacement (With VB6) , Air Conditioning Compressor Replacement (Without VB6) .
  2. Drain the engine oil. Refer to Engine Oil and Oil Filter Replacement .
    3. Fig 1: View of Engine Oil Level Sensor & Electrical Connector
    GM551033Courtesy of GENERAL MOTORS COMPANY
  3. Disconnect the electrical connector (2) from the engine oil level sensor (1).
  4. Remove the engine oil level sensor (1) from the oil pan.
scientia non olet · About LEMON Manuals