Circuit/System Verification
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON, observe the scan tool Driver Door Ajar Sw parameter while opening and closing the driver door. The parameter should change between Active and Inactive.
- If the value does not change, refer to Driver Door Ajar Malfunction in Circuit/System Testing .
- Observe the scan tool Passenger Door Ajar Sw parameter while opening and closing the right front passenger door. The parameter should change between Active and Inactive.
- If the value does not change, refer to Passenger Door Ajar Malfunction in Circuit/System Testing .
- Observe the scan tool Left Rear Door Ajar Sw and Right Rear Door Ajar Sw parameters while opening and closing the rear passenger doors. The parameters should change between Door Closed and Door Ajar.
- If the value does not change, refer to Rear Door Ajar Malfunction in Circuit/System Testing .