LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Solstice Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 5L40-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Transmission Internal Electrical Harness Replacement >> Removal Procedure

Removal Procedure

  1. Remove the Transmission fluid pan and filter. Refer to Automatic Transmission Fluid and Filter Replacement .
    2. Fig 1: Identifying Transmission Wiring Harness Connector & Locking Latch
    GM785868Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the transmission wiring harness connector (1) from the transmission by rotating the locking latch (2) counterclockwise.
    3. Fig 2: Identifying Transmission Internal Wiring Harness Components
    GM822499Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the internal wiring harness from components (1-8).
    4. Fig 3: Identifying Internal Wiring Harness & Retainer
    GM812734Courtesy of GENERAL MOTORS CORP.
  4. Remove the internal wiring harness retainer (2) from the internal wiring harness (1).
    5. Fig 4: Identifying Internal Wiring Harness & O-ring Seals
    GM792825Courtesy of GENERAL MOTORS CORP.
  5. Remove the internal wiring harness (2) from the transmission.
  6. Remove the O-ring seals (3) from the internal wiring harness (2) only if the O-rings are cut or worn.
scientia non olet · About LEMON Manuals