Removal Procedure

Remove the transmission fluid pan and filter. Refer to Automatic Transmission Fluid and Filter Replacement .

Fig 1: Identifying PCS & Electrical Wiring Harness Connector

Courtesy of GENERAL MOTORS CORP.

Disconnect the electrical wiring harness connector (2) from the pressure control solenoid (1).

Fig 2: Locating Solenoid Retainer

Courtesy of GENERAL MOTORS CORP.

Using a small screwdriver or pick, remove the pressure control solenoid retainer from the control valve body.

Fig 3: Exploded View Of PCS

Courtesy of GENERAL MOTORS CORP.

Remove the pressure control solenoid (1) from the control valve body.
Remove the O-ring seals (3-4) from the pressure control solenoid (1), ONLY if the O-rings are cut or worn.