LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Solstice Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 5L40-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Control Valve Body Accumulator Assembly Replacement >> Removal Procedure

Removal Procedure

  1. Remove the transmission fluid pan and filter. Refer to Automatic Transmission Fluid and Filter Replacement .
    2. Fig 1: Identifying Transmission Internal Wiring Harness Components
    GM822499Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the internal electrical wiring harness connectors from all internal electrical components (1-8).
    3. Fig 2: Locating Valve Body Assembly Bolts
    GM812785Courtesy of GENERAL MOTORS CORP.
  3. Remove ONLY bolts (1, 3) from the valve body assembly. Do NOT remove bolts (2) called out in the graphic.
    4. Fig 3: Identifying Control Valve Body Accumulator Assembly, Manual Shaft Detent Assembly, & Bolts
    GM812731Courtesy of GENERAL MOTORS CORP.
  4. Remove the bolts (3) securing the control valve body accumulator assembly (1) and manual shaft detent assembly (2) to the transmission case.
  5. Remove the manual shaft detent assembly (2) and control valve body accumulator assembly (1) from the transmission.
    6. Fig 4: View Of Fluid Passage Sleeves
    GM812730Courtesy of GENERAL MOTORS CORP.
  6. Remove the fluid passage sleeves only if replacement of the sleeves is necessary.
scientia non olet · About LEMON Manuals