Prop Flange Assemble

Special Tools 

J 8614-01:  Flange and Pulley Holding Tool

For equivalent regional tools, refer to Special Tools .

Fig 1: Identifying Prop Shaft Flange Components
Courtesy of GENERAL MOTORS CORP.
1. Install the NEW output shaft assembly retainer (30).
2. Install the NEW prop shaft flange o-ring seal (32) into the prop shaft flange (31) - model dependent.
3. Install the prop shaft flange (31).
4. Put the transmission in Park.
CAUTION: Refer to Fastener Caution .
5. Install the NEW prop shaft flange thrust washer (33) and NEW prop shaft flange nut (34) using GM P/N 89021297. Tighten the prop shaft flange nut (34) to 57 N.m (42 lb ft).
6. Using either the J 8614-01:  holding tool to tighten the prop flange nut.