LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> G8 Base >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 5L40-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Transmission Rear Mount Replacement >> Installation Procedure

Installation Procedure

    NOTE: The engine mounts must NOT bend or deflect from the vertical position. Damage to the mount will occur.
  1. Install the transmission mount to the vehicle.
    2. Fig 1: Identifying Transmission Mount Bolts
    GM1559378Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the transmission mount retaining bolts and tighten to 60 N.m (44 lb ft).
  3. Install the transmission support. Refer to Transmission Support Replacement (5L40 and 6L50) .
  4. Remove the jack and block of wood.
  5. Install the exhaust system.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals