LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> G8 Base >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 5L40-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Transmission Fluid Cooler Hose/Pipe Replacement >> Removal Procedure

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the front air deflector. Refer to Front Air Deflector Replacement .
    3. Fig 1: Identifying Transmission Cooler Lines & Flexible Hoses
    GM1957881Courtesy of GENERAL MOTORS CORP.
  3. Place an oil drain pan under the transmission fluid cooler pipes (1&2) near the radiator.
    4. Fig 2: Cooler Line & Quick Connect Fitting
    GM104740Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the transmission fluid cooler pipes from the transmission fluid cooler by using the J 44827  . See Special Tools .
    5. Fig 3: Transmission Fluid Cooler Pipes Bracket Retaining Bolt
    GM1955690Courtesy of GENERAL MOTORS CORP.
  5. Remove the transmission fluid cooler pipes bracket retaining bolt.
    6. Fig 4: Transmission Fluid Cooler Pipes Retaining Bolt
    GM1955741Courtesy of GENERAL MOTORS CORP.
  6. Remove the transmission fluid cooler pipes retaining bolt.
  7. Remove the transmission fluid cooler pipes.
  8. Remove and discard the O-rings. Do not reuse the O-rings.
scientia non olet · About LEMON Manuals