Installation Procedure
- Align the transmission control module with the locating pins (2) on the module mounting bracket.
- Install the transmission control module by seating it fully into the bracket until all of the retaining tabs (1) have engaged the edge of the module edge.
- Install connectors (1) into the right hand side junction box
- Carefully connect the transmission control module electrical connector (1) to the transmission control module.
- Lock the transmission control module electrical connector securely to the transmission control module by pushing the retainer (2) toward the electrical connector (1) until fully seated.
- Install the right side hinge pillar trim on the vehicle. Refer to Body Hinge Pillar Trim Panel Replacement .
- Install the knee bolster assembly. Refer to Knee Bolster Replacement .
- If re-programming is required. Refer to Control Module References .
- Reset the TAP values. Refer to Transmission Adaptive Functions .
IMPORTANT:
Twisting or tilting of the transmission control module electrical connector while connecting may result in bent or misaligned electrical terminal pins.
IMPORTANT:
It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM or TCM will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM or TCM will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.