Torque Converter Housing Installation

Fig 1: Measuring Dimension X

Courtesy of GENERAL MOTORS CORP.

Measure the distance from the bottom of the gage bar to the top of the direct and reverse clutch assembly (6). Record this as dimension X. Refer to the Reverse Clutch Housing Selective Thrust Washer Specifications to determine the correct size to use.

Fig 2: Locating Torque Converter Fluid Seal

Courtesy of GENERAL MOTORS CORP.

Use lubricant to install the NEW torque converter fluid seal (4) onto the torque converter housing.
Use lubricant to install the reverse clutch housing thrust washer (5).

Fig 3: View Of Fluid Pump Cover Gasket

Courtesy of GENERAL MOTORS CORP.

Fig 4: Identifying Torque Converter Housing Bolts Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Tighten the torque converter housing retaining bolts in sequence to 22 N.m (16 lb ft).