Removal Procedure

Remove the transmission fluid pan and filter. Refer to Automatic Transmission Fluid and Filter Replacement .

Fig 1: View Of TCC PWM Solenoid Valve & Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Disconnect the electrical connector (1) from the torque converter clutch (TCC) pulse width modulation (PWM) solenoid valve (2).

Fig 2: Locating Solenoid Retainer

Courtesy of GENERAL MOTORS CORP.

Using a small suitable tool, remove the TCC PWM solenoid valve retainer from the control valve body.

Fig 3: Exploded View Of TCC PWM Solenoid Valve

Courtesy of GENERAL MOTORS CORP.

Remove the TCC PWM solenoid valve (1) from the control valve body.
Remove the O-ring seals (3-4) from the TCC PWM solenoid valve (1), ONLY if the O-rings are cut or worn.