LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> G8 Base >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 5L40-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Shift Control Linkage Replacement >> Removal Procedure

Removal Procedure

  1. Place the selector lever in PARK.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    3. Fig 1: Identifying Shift Control Linkage Rod
    GM1954218Courtesy of GENERAL MOTORS CORP.
  3. Remove the nut from the shift control linkage rod.
  4. Disconnect the shift control linkage rod from the shift control.
    5. Fig 2: Identifying Shift Selector Linkage Rod To Shift Selector Shaft Retaining Nut
    GM1958702Courtesy of GENERAL MOTORS CORP.
  5. Remove the shift selector linkage rod to shift selector shaft retaining nut (3).
  6. Remove the shift selector linkage rod (1) from the shift selector shaft (2).
scientia non olet · About LEMON Manuals